Everyone should know that tiling is not a simple technology and requires great care and caution. Because of a little carelessness, it is prone to emptying and irregularities, which will affect the overall appearance. Then how to shop tiling it? Need to pay attention to details when posting? Follow Xiaobian to learn about it! First, tile the steps 2. The vertical line should be suspended before the paving begins to determine the dimension line of the tiles so that the surface can be smooth when paving, and the tiles can be horizontally and vertically. 3, the next set of wood pallets should be based on the level of the line, and then set up to play a supporting role of the wooden pallets. The purpose is to prevent the possibility of the tiles falling or shifting before the bonding material has hardened to build up strength. 4, the next tile. It usually begins with doors and windows, and proceeds from bottom to top and from left to right. The method of paving is to wet the leveling layer with water first, then use a shovel to apply the pre-mixed adhesive material on the back of the tile, and then the tile is attached to the wall. Of course, gray rubber hammers are also used to tap, so that the adhesive material can fill the gap between the tiles and the wall, and then lay flat can be. Finally, if there is any excess adhesive material found on the perimeter of the tile, it should be removed in time. It is recommended to wipe off the stain on the tile with a wet cotton cloth. Do not wait until the adhesive material is hard and then wipe, otherwise it is difficult to handle clean. Second, pay attention to the details of tile 1, before the tiling tile must be guaranteed, because the exposed pipe is very unsightly, and the sound when the water will be very large, so the process of ensuring this is very important. You can use soundproof cotton to wrap the pipe, and then use bricks to build it up, so that the isolation effect is very good. 2, if it is to tile the bathroom tile, it should pay attention to the issue of waterproof. Because the water absorption of the wall after waterproofing will be relatively poor, so the waterproofed wall needs to be reinforced with tile adhesive when getting tiles, so as to avoid the phenomenon of losing bricks. Xiao Bian Conclusion: The above is the need to pay attention to what the details of the introduction of the method when tiling and tiling, hoping to play a role in helping. In this small series to remind everyone that the order of laying tiles should be posted on the wall and then posted to the ground, first posted inside the house and then posted the door, and then it must be dried before stepping on. Electrolyte Additive,Iodine Crystal Granule Crystal,Iodine Crystal,Cas 7553-56-2 Henan Tianfu Chemical Co.,Ltd , https://www.tianfuchem.com
1. Soak the tiles with water for about 2 hours before applying tiles. The purpose of the soaking is to allow the tiles to absorb enough moisture beforehand to avoid the moisture in the adhesive material after the plaster is applied, thereby affecting the strength of the bonding, or causing the over-contraction of the bonding material to cause hollowing, de-bonding, and the like. Happening. After soaking in water, remember to use a cotton cloth to wipe off the surface moisture before drying. 
