Commercial Vinyl Flooring,Pvc Flooring,Hospital Pvc Flooring,Non-Directional Pvc Flooring JIANGSU HUAJING FLOOR TECHNOLOGY CO.,LTD , https://www.huajing-floor.com
2SK water ring vacuum pump equipment installation and maintenance
[Asia Pump Network News] Only by correctly installing and using the vacuum pump to ensure the normal operation of the vacuum pump to ensure the life of the pump. Now to say 2SK water ring vacuum pump equipment installation and maintenance. 2SK water ring vacuum pump structure 1, 2SK water ring vacuum pump installation 1, 2SK water ring vacuum pump installation: 2SK water ring vacuum pump on the package arrived at the installation site, if found damaged or 8 months after delivery For installation, the installation should be completely opened before inspection and repair. Apply hand before turning the coupling shaft Lu to confirm whether the pump stuck phenomenon. (2SK-0.4, 2SK-0.8 pump can find the motor cover, turn the motor fan a few laps to check), 2SK water ring vacuum pump should be based on the level to ensure that the pump placed horizontally. 2, 2SK water ring vacuum pump pipe installation: 2SK water ring vacuum pump flange connection at the application of heat to make it a reliable fit, especially the 2SK water ring vacuum pump intake line slightly less stringent Where you can not reach the predetermined degree of vacuum. The intake pipe near the pump must be equipped with a gate valve to close before stopping, to prevent the water in the pump from flowing back to the intake pipe or even the sealed container under the action of the exhaust pipe. It is best to install a vacuum gauge between the intake valve and the air inlet of the pump so as to check whether the pump is normal at any time and the gate valve should also be installed on the water supply pipe of 2SK water ring vacuum pump so as to adjust the water supply to meet the requirements . 3,2SK water ring vacuum pump gas-water separator installation: 2SK water ring vacuum pump gas-water separator placed on the foundation according to Figure VIII, if necessary to change the installation location, it should be noted that the separator connection pipeline must not be too long , The transition must not be too urgent (requires the connection pipe and pump inlet distance, the maximum not more than half a meter, the longest not more than 2 meters, not more than three changes, or water and gas in the pipe will increase the loss of flow, Thus increasing the pump exhaust pressure, thus reducing the flow and vacuum, increasing the power consumption. 2SK water ring vacuum pump maintenance 1, 2SK vacuum pump should be regularly compressed packing, such as packing due to wear and can not be guaranteed The required seal should be replaced by a new filler, the filler can not be pressed too tight, the normal pressure of the packing allows the water to drip, but not too much, the application of oil asbestos rope filler .2SK vacuum pump ball bearings should be good Of the working conditions, the working temperature shall not exceed the ambient temperature 35 ℃, but the measured temperature should not exceed 70 ℃, the entire bearing room 2/3 of the full space filled with butter, the normal work of the bearing should be annually Oil 3-4 times, at least once a year to clean the bearings, and all the lubricating oil replacement .Read more: Pumps Valves Pipe Fittings Exhibition Water Expo Xiamen Maritime Expo Internet + Forum Yiwu Expo Mold Top Ten Brands 2016 Exhibition Information Internet industry (Xiamen) Technology Co., Ltd. author: Asian pumps network editor: Yao Xiaoxia (QQ / micro letter:) http://beng.liuti.cn/ (service hotline:)