What is the bathroom floor slope standard?

<

People usually only consider how beautiful and stylish the decoration is when they are decorating, but at the same time they tend to ignore small details. For example, when the bathroom is being renovated, there is no slope, which leads to the accumulation of toilets on some people’s floors. A flood of water, the long run, flooding will affect the use of bathroom functions or damage the waterproof layer, causing water leakage on the ground. So, how do you do when the bathroom floor is not sloped? What is the bathroom floor slope standard ? Let's take a look with Xiaobian.

First, why do bathroom floors be sloped?

Because of the water in the bathroom, in order to allow the water to flow into the floor drain as quickly as possible, the ground must have a certain slope. There is no specific requirement for the size of the slope. Some owners prefer a small slope, as long as no water is left on the line. Some owners need a relatively large slope. In order to make the water faster, even if the water is not running, the water will not flow out when bathing.

Second, what is the bathroom floor slope standard?

The floor elevation of the bathroom should be 20-50mm lower than in the room. The ground-drainage drainage slope is one to two percent to three percent. When the bathroom is backfilled and leveled, it should be radiated in four directions with the floor drain as the center, and the gradient should be determined. The slope should be leveled with a scraping ruler. The surface should be smooth, the surface should be flat, no gap, no sand, and no accumulation of water should prevail.

Not only does the ground need a slope, but also when the water pipe is installed, the slope of the water pipe should be taken into consideration. The water supply pipe should be sloped from 0.002 to 0.005 to the drainage device or water distribution point. The water supply pipe should have a slope gradient of not less than 0.003 to the outdoor water supply. tube.

Third, how to do without a grade?

1, redo: In case of such a situation, if you do not bother to re-floor tiles, the mason to remove the floor tiles, try not to damage the waterproof layer, to find the water slope. Otherwise, it can only be used, so be sure to pay attention to this problem when the bathroom floor construction, or the last trouble is still their own.

2, the use of shower room: If you feel re-do trouble, it is recommended to use the shower room at home, try to avoid splashing water. But be sure to use a waterproof strip!

3, drainage: or you can use in the wall brick seams, cutting with a cutting machine, but can not cut too deep, as long as the water can flow away, this can ensure that the toilet water will not collect water. If the original tiles are shaved off, the renovation will cost a lot of money. If it is to find a decoration company, it can be held responsible for the decoration company and let the decoration company take charge.

What about the bathroom floor slope standard and how the bathroom floor does not have a slope? This is a brief introduction here, and I hope to help you. For more information, please visit this website. Stay tuned.

Toilet bathroom decoration bathroom design

The xunda Epoxy Primer is a specially formulated 100% volume solid (solvent less) high temperature two component epoxy.  Epoxy primer mainly by modified epoxy resin as main film former, using active dilutes toughening agent without solvent. Give good layer relay, good chemical stability and mechanical properties.

The composition of pipeline epoxy primer consists of two components, part A, part B.

Part A:  Epoxy resin

Part B:  Active dilutes toughening agent

Epoxy Primer

Epoxy Primer,Epoxy Primer Paint,2K Epoxy Primer,2 Part Epoxy Primer

Jining xunda pipe coating materials co., ltd. , https://www.pipeanticorrosion.com