Indoor decoration acceptance notice

<

1, water pipes: Galvanized Pipe teeth less than 8 teeth, raw material with more than 6 winding wrapped tightly, not rotten teeth. Plastic pipe or aluminum plastic pipe Note that the installation of special tools, in strict accordance with the provisions of the operation, the final pressure test (pressure test is greater than 24 hours).
2. Pay attention to the discharge of water pipes from the wall. Do not leave the floor, under the floor tiles, or at high altitude. If you must go to the floor and floor tiles, the installation of the water pipes must be straight and no joints are allowed. The valves should be installed on the ground. The water inlet pipes of the buckets should be equipped with triangular valves.
3, electrical circuit emissions, in addition to hollow floor, but also to wear the pipe, such as the use of PVC pipe, the wall thickness of not less than 1.2mm. The electric circuit discharges the wall body and does not go under the floor or the floor tile.
4, gas (natural gas) to use the bright tube, control slope, joints to use thick white linen paint, do not use raw materials, but also to test gas.
5. In the end, don’t forget to let the construction team leave the wiring diagrams, especially the dark lines. Be sure to leave accurate electrical wiring diagrams in case you need urgent repairs.

Nature floor del floor electrical paint floor tile

Reinforcing bar,or Deformed Steel Rebar, is a common steel bar that is hot rolled and is used widely in the construction industry, especially for concrete reinforcement. Steel rebar is most commonly used as a tension devise to reinforce concrete and other masonry structures to help hold the concrete in a compressed state. Concrete is a material that is very strong in compression, but virtually without strength in tension. 

To compensate for this imbalance in a concrete slab's behavior, reinforcement bar is cast into it to carry the tensile loads. Common steel or concrete reinforcement bar is supplied with heavy ridges to assist in binding the reinforcement to the concrete mechanically - this is commonly referred to as deformed rebar. Deformed Steel Rebar is used to be called Screw thread steel.

Steel Rebar is a steel bar or mesh of steel wires used as a tension device in reinforced concrete and reinforced masonry structures to strengthen and hold the concrete in compression. Concrete is strong under compression, but has weak tensile strength. Rebar significantly increases the tensile strength of the structure. Rebar's surface is often patterned to form a better bond with the concrete.

 

Product Name
mild steel bar price /steel rebar /iron rods for construction/concrete
Standard
BS4449-2005,GB1449.2-2007,JIS G3112-2004, ASTM A615-A615M-04a,
Korea StandarsKS D 3504, AustralasianStandard AS/NZS 4671
Grade
BS4449, Gr460B,Gr500B, GB1449.2, HRB335, HRB400, HRB500, HRB400E,HRB500E, ASTM A615, GR40/GR60/GR75, JIS G3112,SD390,SD360 Korea StandarsKS D 3504 SD400 SD500 SD600, AustralasianStandard GR500N
Size
6mm,8mm,10mm, 12mm, 13mm, 14mm, 16mm, 20mm, 22mm, 25mm, 30mm, 32mm, 40mm,50mm, etc..
Application
civil engineering construction,such as housing, bridges,road, etc
Delivery
Normally 3-10 days after receive deposits or L/C at sight.
Package
Packed in bundle, standard seaworthy package or customers` requirements.

Deformed Steel Rebar

Steel Rebar

Deformed Steel Rebar

Application:

Construction project ,bridge and building etc.

 

If you have any questions, please contact with us directly.
Our company is solemnly committed to the majority of customers: reasonable price, short production cycle, considerate service. We look forward to cooperating with you.

 

 

 

 

 

 

 

 

 

 

 

 

Deformed Steel Rebar

Deformed Steel Rebar,Deformed Steel Bar,Deformed Steel Bar For Construction,Deformed Steel Bars

Shandong Vantage International Trade Co., Ltd. , http://www.sdvantage.com