Flat steel is manufactured using negative deviation rolling technology, which allows for a more efficient use of material. Although it is delivered based on actual weight, this method can increase the utilization rate by 1 to 5 percentage points compared to traditional steel plates. This not only improves material efficiency but also reduces waste during the production process. Additionally, flat steel can be customized in thickness, width, and length according to specific user requirements. This flexibility helps minimize cutting needs, streamline the manufacturing process, and reduce both labor and material costs. It also lowers the risk of raw material loss during processing, saving time and effort for the end user. Our flat steel products are widely used across various industries, including steel structure manufacturing, machinery production, automotive components, mining equipment, and lifting systems. With its high adaptability and cost-effectiveness, flat steel has become an essential material for industrial applications worldwide. Chemical Industry Mass Flow Meter
Sealand is a professional supplier of Chemical Mass Flow Meter, Chemical Mass Flowmeter, Chemical Flowmeter, Chemical Flow Meter, Chemical Coriolis Meter, ATEX, IECEx & CE approved.
The meter can work with a pulse receiver(Count). The connection is as follows. The
resistance value is up to the cable length & the max. input pulse frequency of receiver.
Current 10mA is suitable for most receivers; however, you can reduce the resistance value
when the cable is long. The max. current could be 50mA. Please use the fixed frequency
output function to check if the cable length & resistance value is suitable.
Please check following items before operation, and operate according to relevant rules.
a) If the meter is damaged during shipment and installation;
d) If the meter is grounded properly.
Chemical Mass Flow Meter, Chemical Mass Flowmeter, Chemical Flowmeter, Chemical Flow Meter, Chemical Coriolis Meter Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeter.com
b) If the voltage is same as marked on nameplate;
c) If the fuse is correct;
e) If the Meter SN on the nameplate of sensor and transmitter are the same.
If everything is fine, please open all valves, make the pipeline full of liquid and then power on
the meter for warm-up for 20min before operation. Finally, conduct zero calibration after first
start, and shall do it again if the meter is moved to another site.
Preparation for zero calibration:
a) Power on the meter for approximately 20min for warm-up;
b) Run the process fluid through the sensor until the sensor temperature reaches the normal
process operating temperature.
c) Close the shutoff valve downstream from the sensor.
d) Ensure that the sensor is filled with fluid and the process flow has completely stopped.