Experience exchange drought resistance When the river has drought-resisting water sources, it can turn off and turn on the water from the 3 units. Controlled water equipment. 3 Influent irrigation channels When the river water level is high, when it can realize gravity irrigation, it can be closed. Open the 7JC flow through the pipe BA and enter it through 3. Irrigation canal; When the waterless source of inland water needs to be raised for irrigation and drought resistance, it can be turned on and off, and the water flowing out of the river reaches the pump pool. The water pump catches the pressure and the water passes through the pull gate to enter the filling rack. 3 The operation of the project Currently, Xiangyin Five pumping stations in the county have adopted multi-use tube technology. The establishment of a condominium-fed type built with the early suitable 199, Shipai, station, calendar. 0 years old, the factory is normal; the two pipes have the highest elevation difference, and the largest pipe diameter is the Nanmen Port pumping station. It was built in 1995 with installed capacity of 4951. The two characters have a height difference of 5. and a diameter of 2 to 2 .1. Experienced the highest level of water in 1996, and also experienced the longest period of continuous high flood level in Dongting Lake in 1998. It is in good condition. The Liulin River Pumping Station, built by bypass co-management, was built in 1995 and operated well for many years. Practice has proved. The multi-purpose pumping station is a reliable and reliable system for the management of transportation halls and the multi-functionality of the units. 41. Benefits The use of the multi-use pumping station for water outlets is compared with the use of double inlets and outlets. In addition to the addition of two control sluice gates, the construction site has increased the difficulty and cost of construction, but has reduced floodgate seats. It can reduce the amount of civil engineering work, greatly reduce the total construction cost, and shorten the total construction period. The greatest benefit of this technology is to reduce the potential hazards of wearing dykes and eliminating flooding on embankments. Therefore, in the construction of the multi-functional drainage pump station in the lake area, it has extensive popularization value. Generator Cleaning Method Experience Introduction He Ming Shaodong County Huangjiaba Reservoir Management Institute Shaodong County 422800 After the generator runs for a period of time, oil dust often appears at the end of the generator. Due to its influence, the generator insulation strength is reduced, and the service life is shortened. . Based on our many years of practice, we have explored an easy way to remove oil from generators. The oil dirt on the generator end can be removed. Chlorocarbon or solvent gasoline can be used. Toluene has a good effect on oil removal, but toluene is toxic to the human body and is used as little as possible. Gasoline is convenient and easy to take, and its detergency is also strong. Therefore, using gasoline to clean the oil dirt on the generator end is a convenient and economical method. The use of gasoline to clean the oil dirt on the generator's end is simple and convenient. The specific procedure is to first use a smooth bamboo blade to scrape the dirt sticking to the end of the coil from the top to the bottom, and Scraped dust is removed. The Air Compressor and the vacuum cleaner are used to remove the dust falling in the tank from top to bottom. The dust can be replaced by a compressed atomizer in the place where there is no air compressor or vacuum cleaner. Repeat the above procedure several times until the dirt is completely removed. Second, use a new piece of cotton yarn or a soft cloth tightly wrapped around the tip of the bamboo strip. Wash several times and then use the next net of cotton yarn or soft cloth to wipe the tip, until the end of the winding bulb drying, and then can be coated with insulating paint to improve edge strength, after drying can be. During the work time. Care should be taken to check that the bamboo slips are smooth, and that non-smooth bamboo strips should not be used to scratch dirt to damage the insulation. When scratching, use a moderate amount of force and do not overemerge. Scratch scratching, scrubbing should be twisted than the next tank-by-slot, which can avoid repeated operations, reducing the number of brushing. To increase the efficiency of 1 should use pure gasoline, do not use oil containing other impurities maintenance quality. It is not advisable to use an open flame during baking. It is advisable to bake with a light bulb to avoid damage to the insulation. Before and after cleaning, all records should be detected and well-prepared, especially if insulation is strong and small. In order to make a comparison before and after, it is a feasible and convenient method to increase the insulation strength after applying the gasoline cleaning, applying insulating oil, and drying after the drying. Arctic Air Cooler strong wind but quietly operation. Arctic Air Cooler arctic air fan,arctic air cooler reviews,arctic air conditioner reviews,arctic aire,arctic cool air conditioner SHIJIAZHUANG TOPA TRADING CO., LTD. , https://www.topahydraulic.com
Arctic cooler choose from 3 speeds and adjust the airflow.
Arctic air conditioner with LED light, can be used as soothing night light.
arctic air fan spray design help you do a DIY SPA, drop your favorite essential oil into water.
Great for home and office use.